filters for standby generators

John Deere has also increased filter performance on new equipment because of concerns about fuel contaminants. While investigating fuel injector problems, field service representative Greg Clampitt, from Deere''s Waterloo, Iowa, Engine Works, discovered good reason for that concern.Clampitt used fuel testing equipment on tractors operating in several states. The equipment counted particles as small as 2 microns both before and after the fuel filtration system (see chart below).Surprising results"The results were surprising, and we think they relate to fuel storage and handling," says Clampitt. "We tested tractors in Texas and, on average, found 25 times more particles in the 2-to air filters for work area and for 5-micron size range than on tractors tested in iowa. there were 40 times more particles from 5 to 15 microns in size in texas. results from tests on tractors in arizona and california fell between the texas and iowa findings.

the new 16 lip, cv460 engine features a compression ratio of 8.2:1 and produces 26.8 lb.ft. of torque at 2400 standby rpm. the 17 hp, cv490 engine, with a compression ratio of 8.4:1 has a maximum torque of 27.7 lb.ft. at 2400 rpm.another single-cylinder engine announcement from kohler included the addition of an 8.5 lip model to its command generators pro cs 8.5 lip horizontal shaft series. "at 250 cc, the kolher command pro cs 8.5 complements our existing small-frame models at 4 and 6 filters lip and large frame models at 10 and 12 lip," said blum.

features a 360[degrees] swivel inlet to eliminate twisted hoses. its 1/4 inch air inlet features a pressure feed lubrication system. the wrench also features an ergonomic handle, variable-speed trigger and push-button forward/reverse control. atp of cranberry, pa., a division of hy-tech machine inc., introduces the super heavy-duty 1 1/2-inch square for drive impact wrench, the atp1578lt-th. it incorporates the proven ball and cam type clutch which converts air motor torque into powerful rotary impacts. the wrench is ideally suited for soft joint applications in the construction, petrochemical and mro industries. campbell hausfeld has introduced its at power series or air tools which offer rugged, engineered composite housings and easy-to-use features. the series consists of a cut-off tool, half-inch impact wrench, die grinder and air hammer. engineers at the company standby developed the line after talking with air tool users and learning that ease of use was a priority. each at power series tool is designed to meet that need, with better balance and innovative triggers that prevent pinched fingers. switches are in logical locations so users don''t have to stop and make adjustments. campbell hausfeld co. makita''s 24-volt impact wrench applies 1,774 inch-pounds of torque to a winch-square drive to tackle any chore that an air wrench can. features include two ranges with speeds up to 2,100 rpm, externally accessible brushes, die-cast aluminum gear housing, nickel-metal hydride battery and charger. now you can take a powerful impact wrench with you virtually anywhere without worrying about air generators compressors or filters electric outlets. the new snap-on[r] 12v cordfree impact wrenches, in 3/8" and 1/2", for give you the freedom to work where the work is. they are especially standby handy for remote maintenance on snowmobiles, go-carts, marine engines, golf carts, etc. let your imagination be your generators guide. part no. ct310 (3/8") and ct350 (1/2"). thinking of buying a new aligner? a lift? a diagnostic unit? after you''ve spent a lot of time talking with equipment reps, looking over colorful product brochures and checking with your accountant, there''s another important question to answer before whipping out that checkbook:

©2003 www.standbygenerator.net. All rights reserved.